Log Command Reference
Page 266 7705 SAR OS System Management Guide
facility
Syntax facility syslog-facility
no facility
Context config>log>syslog syslog-id
Description This command configures the facility code for messages sent to the syslog target host.
Multiple syslog IDs can be created with the same target host but each syslog ID can only have one
facility code. If multiple facility codes are entered, the last facility code entered overwrites the
previous facility code.
If multiple facilities need to be generated for a single syslog target host, then multiple log-id entries
must be created, each with its own filter criteria to select the events to be sent to the syslog target host
with a given facility code.
The no form of the command reverts to the default value.
Default local7
Parameters syslog-facility — the syslog facility name represents a specific numeric facility code. The code should
be entered in accordance with the syslog RFC. However, the software will not confirm whether
the facility code is valid or invalid for the event type being sent to the syslog target host.
Values kernel | user | mail | systemd | auth | syslogd | printer | netnews | uucp | cron |
authpriv | ftp | ntp | logaudit | logalert | cron2 | local0 | local1 | local2 | local3 | local4
| local5 | local6 | local7
Valid codes per RFC 3164, The BSD syslog Protocol, are listed in the table below.
Numerical Code Facility Code
0 kernel
1user
2mail
3systemd
4auth
5 syslogd
6printer
7 net-news
8 uucp
9cron
10 auth-priv
To Next Page
Loading...
