2. Climb threshold m/s, the Vario will start to sound from this value when we climb. The value is
expressed in m/s.
3. Sink threshold m/s, the Vario will start to sound from this value when we sink. The value is
expressed in m/s.
4. Activate ZeroBand, activating this option, when the value of the vario is close to the Climb
Threshold, special tones will be emitted. For example, if our Climb Threshold is 0.1 m/s, when the
Vario is between -0.5 to 0.0 the Vario will use the special tones of ZeroBand.
Change to CLIMB or DRIFT configuration
Pressing these buttons, we will change to the configuration in ascent or descent.
CLIMB DRIFT
Beeps per Second
* note: the beeps configuration is only available in Climb, since in drift the tone is continuous and there are no beeps.
1. Beeps Bar, by moving this bar we will increment (to the right) or decrease (to the left) the number
of beeps per second according to the vertical speed.
2. Beeps values, we visualize the number of beeps that will be reproduced per second at the m/s that
correspond. Following the example image, at 1.0m/s is 1.9 beeps per second, at 2m/s is 2.1 beeps
per second, etc.
To Next Page
Loading...