Publication 1747-RM001G-EN-P - November 2008
8-8 Block Transfer Instructions
Programming Examples
Figure 8.2 Directional
IMPORTANT
To prevent configuration conflicts, it is highly
recommended that each M-file buffer (My:e.x00)
should be used by only one block transfer
instruction.
Table 8.5 Block Transfer Programming Examples
Figure 8.2, "Directional" on page 8-8
Figure 8.3, "Directional Repeating" on page 8-9
Figure 8.4, "Directional Continuous" on page 8-9
Figure 8.5, "Bi-directional Continuous" on page 8-9
Figure 8.6, "Bi-directional Alternating" on page 8-10
Figure 8.7, "Bi-directional Alternating Repeating" on page 8-10
To Next Page
Loading...
