Rockwell Automation Publication 1783-UM003G-EN-P - December 2012 103
Chapter
4
Manage the Switch via RSLogix 5000
Software
Introduction
After you complete Express Setup, you can manage the switch by using RSLogix
5000 software.
EtherNet/IP CIP Interface
Stratix 8000 and Stratix 8300 switches contain an EtherNet/IP network
interface. EtherNet/IP is an industrial automation network specification
maintained by the Open DeviceNet Vendor Association (ODVA). It uses the
Common Industrial Protocol (CIP) for its application layer, and TCP/UDP/IP
for its transport and network layers. This interface is accessible via any of the
switch's Ethernet ports by using the IP address of the switch.
Topic Page
EtherNet/IP CIP Interface 103
Add a Switch to the I/O Configuration Tree 108
Configure Module Properties 110
Connection Properties 113
Switch Configuration Properties 114
Port Configuration Properties 116
Advanced Port Properties 117
Port Thresholds (Storm Control) 120
Save and Restore Switch Configuration 138
Port Status 125
Switch Status 124
Port Status 125
Cable Diagnostics 128
DHCP Address Assignment Overview 132
Time Sync Configuration Overview 134
Time Sync Information Overview 136
Save and Restore Switch Configuration 138
To Next Page
Loading...
Need help?
General
