AT-9000 Switch Command Line User’s Guide
Section XI: Management Security 1125
TELNET6
Syntax
telnet6
ipv6_address
[
port
]
Parameters
ipv6_address Specifies the IPv6 address of a remote device you want
to manage using the Telnet client on the switch. You
can specify just one address.
port Specifies the protocol port number of the Telnet client.
The default value is 23.
Mode
Privileged Exec mode
Description
Use this command to start Telnet management sessions on network
devices that have IPv6 addresses. You can manage just one remote
device at a time.
This command is available from local and Telnet management
sessions.
Example
This example starts a Telnet management session on a network device
that has the IP address 45ac:be45:78::c45:8156:
awplus> enable
awplus# telnet6 45ac:be45:78::c45:8156
To Next Page
Loading...
