AT-9000 Switch Command Line User’s Guide
Section IX: Simple Network Management Protocols 811
NO SNMP-SERVER HOST
Syntax
no snmp-server host
ipaddress
traps|informs version 1|2c
community_string
Parameters
ipaddress Specifies the IPv4 or IPv6 address of a trap or inform
receiver to be removed from a community string. You
can specify only one IP address.
traps|informs Specifies the type of messages the switch is sending
to the receiver.
1|2c Specifies the format of the messages that the switch
is transmitting to the receiver. You can specify only 2c
when you are deleting the IP address of an inform
message receiver.
community_string Specifies the SNMP community string to which the IP
address of the trap or inform receiver is assigned.
This parameter is case sensitive.
Mode
Global Configuration mode
Description
Use this command to remove IP addresses of trap or inform receivers from
the community strings on the switch. You can remove only one receiver at
a time with this command. The switch does not send any further SNMP
trap or inform messages to network devices after their IP addresses have
been deleted from the community strings.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 132
Examples
This example removes the IPv4 address 115.124.187.4 of a trap receiver
from the private community string:
awplus> enable
awplus# configure terminal
To Next Page
Loading...
