Chapter 33: Static Port Trunk Commands
452 Section V: Port Trunks
SHOW STATIC-CHANNEL-GROUP
Syntax
show static-channel-group
Parameters
None.
Modes
User Exec mode and Privileged Exec mode
Description
Use this command to display the member ports of static port trunks on the
switch. An example of the command is shown in Figure 83.
Figure 83. SHOW STATIC-CHANNEL-GROUP Command
To view the load distribution methods of static port trunks, display the
running configuration with “SHOW RUNNING-CONFIG” on page 132.
Example
awplus# show static-channel-group
% Static Aggregator: sa1
% Member:
port1.0.5
port1.0.6
port1.0.7
% Static Aggregator: sa2
% Member:
port1.0.19
port1.0.20
port1.0.21
port1.0.22
To Next Page
Loading...
