Chapter 53: MAC Address-based Port Security Commands
710 Section VIII: Port Security
NO SWITCHPORT PORT-SECURITY
Syntax
no switchport port-security
Parameters
None.
Mode
Port Interface mode
Description
Use this command to remove MAC address-based security from the ports.
To activate ports that were disabled by the shutdown intrusion
action, refer to “NO SHUTDOWN” on page 181.
Confirmation Command
“SHOW PORT-SECURITY INTERFACE” on page 712
Example
This example removes MAC address-based security from port 14:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.14
awplus(config-if)# no switchport port-security
To Next Page
Loading...
