Chapter 25: Boot Configuration File Commands
382 Section III: File System
SHOW BOOT
Syntax
show boot
Parameter
None.
Mode
Privileged Exec mode
Description
Use this command to display the name of the active boot configuration file
and the version numbers of the management software and the bootloader.
Figure 74 is an example of the information.
Figure 74. SHOW BOOT Command
The fields are described in Figure 37.
Current software : v2.1.1
Current boot image : v2.1.1
Backup boot image : Not set
Default boot config : /cfg/boot.cfg
Current boot config : /cfg/switch2.cfg (file exists)
Table 37. SHOW BOOT Command
Field Description
Current software The version number of the AlliedWare
Plus Management Software on the switch.
Current boot image The version number of the bootloader.
Backup boot image Not supported on the switch.
Default boot config The name of the boot configuration file
used by the switch to configure its
parameters after “NO BOOT CONFIG-
FILE” on page 381. This parameter
cannot be changed.
Current boot config The name of the active boot configuration
file on the switch.
To Next Page
Loading...
