AT-9000 Switch Command Line User’s Guide
Section II: Basic Operations 263
SHOW NTP STATUS
Syntax
show ntp status
Parameters
None.
Modes
Privileged Exec mode
Description
Use this command to determine whether or not the switch has
synchronized its time with the specified NTP or SNTP server. An example
of the information is shown in Figure 59.
Figure 59. SHOW NTP STATUS Command
The IP address is the address of the NTP or SNTP server specified with
“NTP PEER” on page 258. The clock offset is configured with “CLOCK
TIMEZONE” on page 255.
Example
awplus# show ntp status
Clock is synchronized, reference is 149.154.42.190
Clock offset is -5
To Next Page
Loading...
