AT-9000 Switch Command Line User’s Guide
Section X: Network Management 949
NO LOCATION
Syntax
no location civic-location|coord-location|elin-location
identifier
id_number
Parameters
civic-location Deletes a civic location from the switch.
coord-location Deletes a coordinate location.
elin-location Deletes an ELIN location.
id_number Specifies the ID number of the location information to
be deleted from the switch. You can specify only one
location entry at a time.
Mode
Global Configuration mode
Description
Use this command to delete LLDP-MED location entries from the switch.
The same command is used to remove civic locations, coordinate
locations and ELIN locations. You can delete just one entry at a time.
Confirmation Command
“SHOW LOCATION” on page 967
Examples
This example deletes the civic location ID 17:
awplus> enable
awplus# configure terminal
awplus(config)# no location civic-location-id 17
This example removes the coordinate location IDs 6 and 8:
awplus> enable
awplus# configure terminal
awplus(config)# no location coord-location-id 6
awplus(config)# no location coord-location-id 8
To Next Page
Loading...
