Chapter 55: 802.1x Port-based Network Access Control Commands
752 Section VIII: Port Security
AAA AUTHENTICATION DOT1X DEFAULT GROUP RADIUS
Syntax
aaa authentication dot1x default group radius
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to activate 802.1x port-based network access control
on the switch. The default setting for this feature is disabled.
You should activate and configure the RADIUS client software on
the switch before activating port-based access control. For
instructions, refer to Chapter 81, “RADIUS and TACACS+ Clients”
on page 1187 or Chapter 82, “RADIUS and TACACS+ Client
Commands” on page 1203.
Confirmation Command
“SHOW DOT1X” on page 785
Example
awplus> enable
awplus# configure terminal
awplus(config)# aaa authentication dot1x default group
radius
To Next Page
Loading...
