AT-9000 Switch Command Line User’s Guide
Section II: Basic Operations 261
SHOW NTP ASSOCIATIONS
Syntax
show ntp associations
Parameters
None.
Modes
Privileged Exec mode
Description
Use this command to display the settings of the SNTP client. The
information the command displays is shown in Figure 58.
Figure 58. SHOW NTP ASSOCIATIONS Command
The information is described here:
SNTP Configuration:
Status ........................ Enabled
Server ........................ 172.17.118.15
UTC Offset .................... +2
Daylight Savings Time (DST) ... Enabled
Table 21. SHOW NTP ASSOCIATIONS Command
Parameter Description
Status The status of the SNTP client software on
the switch. The status can be either
enabled or disabled. If enabled, the switch
seeks its date and time from an NTP or
SNTP server. The default is disabled.
To enable the client, use “NTP PEER” on
page 258. To disable the client, refer to
“NO NTP PEER” on page 257.
Server The IP address of an NTP or SNTP
server. This value is set with “NTP PEER”
on page 258.
To Next Page
Loading...
