AT-9000 Switch Command Line User’s Guide
Section VIII: Port Security 785
SHOW DOT1X
Syntax
show dot1x
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display whether 802.1 port-based network access
control is enabled or disabled on the switch and the IP address of the
RADIUS server. Only the first IP address in the server table on the switch
is displayed. To view all the server IP addresses, refer to “SHOW
RADIUS” on page 1222. An example is shown in Figure 133.
Figure 133. SHOW DOT1X Command
Example
awplus# show dot1x
802.1 Port-Based Authentication: Enabled
RADIUS server address (auth): 149.32.146.78
To Next Page
Loading...
