Allied Telesis AT-9028 - Show Port-Security Interface; Table 71. SHOW PORT-SECURITY INTERFACE Command

Chapter 53: MAC Address-based Port Security Commands
712 Section VIII: Port Security
SHOW PORT-SECURITY INTERFACE
Syntax
show port-security interface port
Parameters
port Specifies the port whose security mode settings you
want to view. You can display more than one port at a
time.
Mode
Privileged Exec mode
Description
Use this command to display the security settings of the ports on the
switch. An example of the information is shown in Figure 122.
Figure 122. SHOW PORT-SECURITY INTERFACE Command
The fields are described in Table 71.
Port Security Configuration - Port1.0.15
----------------------------------------------
Security Enabled : YES
Port Status : ENABLED
Violation Mode : PROTECT
Aging : NO
Maximum MAC Addresses : 0
Current Learned Addresses : 0
Lock Status : UNLOCKED
Security Violation Count : 0
Table 71. SHOW PORT-SECURITY INTERFACE Command
Field Description
Port Port number.
Security Enabled The current status of MAC address-based
security on the port. The security is active
if the status is Yes and inactive if the
status is No. To activate or deactivate
security on the port, refer to
“SWITCHPORT PORT-SECURITY” on
page 716 or “NO SWITCHPORT PORT-
SECURITY” on page 710, respectively.