Chapter 64: Address Resolution Protocol (ARP) Commands
980 Section X: Network Management
IP PROXY-ARP
Syntax
ip proxy-arp
Parameters
None.
Mode
VLAN Configuration mode
Description
Use this command to enable Proxy ARP on a VLAN interface. Proxy ARP
is disabled by default.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 132
Example
The following example enables Proxy ARP on the interface vlan 10:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# ip proxy-arp
To Next Page
Loading...
