Allied Telesis AT-9028 - Displaying the SNTP Client

AT-9000 Switch Command Line User’s Guide
Section II: Basic Operations 251
Displaying the SNTP Client
To display the settings of the SNTP client on the switch, use the SHOW
NTP ASSOCIATIONS command in the Privileged Exec mode.
awplus# show ntp associations
The following is displayed:
Figure 56. SHOW NTP ASSOCIATIONS Command
The fields are described in Table 21 on page 261.
To learn whether the switch has synchronized its time with the designated
NTP or SNTP server, use the SHOW NTP STATUS command. An
example of the information is shown in Figure 57.
Figure 57. SHOW NTP STATUS Command
SNTP Configuration:
Status ........................ Enabled
Server ........................ 149.134.23.154
UTC Offset .................... +2
Daylight Savings Time (DST) ... Enabled
Clock is synchronized, reference is 149.154.42.190
Clock offset is -5