AT-9000 Switch Command Line User’s Guide
Section V: Port Trunks 451
PORT-CHANNEL LOAD-BALANCE
Syntax
port-channel load-balance src-mac|dst-mac|src-dst-mac|src-
ip|dst-ip|src-dst-ip
Parameters
src-mac Specifies source MAC address as the load distribution
method.
dst-mac Specifies destination MAC address.
src-dst-mac Specifies source address/destination MAC address.
src-ip Specifies source IP address.
dst-ip Specifies destination IP address.
src-dst-ip Specifies source address/destination IP address.
Mode
Static Port Trunk Interface mode
Description
Use this command to specify the load distribution methods of static port
trunks. The load distribution methods determine the manner in which the
switch distributes packets among the ports of a trunk.
This command is found in the Static Port Trunk Interface mode. To enter
the mode, use the INTERFACE TRUNK command. The format of the
command is the keyword INTERFACE followed by name of a trunk you
want to configure. The name of a static port truck consists of “sa” followed
by a trunk’s ID number. You can configure just one trunk at a time.
Example
This example sets the load distribution method to destination MAC
address for a trunk with an ID number 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface sa4
awplus(config-if)# port-channel load-balance dst-mac
To Next Page
Loading...
