Chapter 16: Enhanced Stacking Commands
302 Section II: Basic Operations
NO ESTACK COMMAND-SWITCH
Syntax
no estack command-switch
Parameter
None.
Mode
Global Configuration mode
Description
Use this command to return the enhanced stacking mode on the switch to
member switch from command switch. This command has the following
guidelines:
The default setting for the enhanced stacking mode on the switch is
member. So you would only use this command if you set the mode to
command mode and now want to return it to member mode.
Enhanced stacking must be activated on the switch for you to use the
command. To activate enhanced stacking, refer to “ESTACK RUN” on
page 301.
You cannot use this command on a switch accessed through
enhanced stacking. This command can only be used from a local or
remote management session of the switch.
To configure the switch as a command switch, refer to “ESTACK
COMMAND-SWITCH” on page 300.
Confirmation Command
“SHOW ESTACK” on page 307
Example
This example returns the switch’s stacking status to member switch:
awplus> enable
awplus# configure terminal
awplus(config)# no estack command-switch
To Next Page
Loading...
