Chapter 10: IPv4 and IPv6 Management Address Commands
240 Section II: Basic Operations
SHOW IP ROUTE
Syntax
show ip route
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display the management IP address and the default
gateway on the switch. Figure 53 is an example of the information.
Figure 53. SHOW IP ROUTE Command
The fields are described in Table 17.
----------------------------------------------------------------------------
Destination Mask NextHop Interface Protocol RIPMetric
----------------------------------------------------------------------------
149.102.34.0 255.255.255.0 149.102.34.198 VLAN14-0 INTERFACE 1
0.0.0.0 0.0.0.0 149.102.34.212 VLAN14-0 STATIC 1
Table 17. SHOW IP ROUTE Command
Parameter Description
Destination Not applicable to the AT-9000 Switch.
Mask The masks of the management IP
address and the default gateway address.
The mask of the default gateway is
always 0.0.0.0.
NextHop The management IP address and the
default gateway address. The
management IP address is the first entry
in the table and the default gateway
address is the second entry.
Interface The VID of the VLAN to which the
management IP address is assigned.
To Next Page
Loading...
