EasyManua.ls Logo

Allied Telesis AT-9028 - Page 766

Allied Telesis AT-9028
1278 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 55: 802.1x Port-based Network Access Control Commands
766 Section VIII: Port Security
broadcast and multicast packets while discarding ingress broadcast and
multicast traffic. This is the default setting. Authenticator ports set to the
BOTH option discard both ingress and egress broadcast traffic until a
client has logged on.
This command is only available on authenticator ports that are set to the
single operating mode. Authenticator ports that are set to the multiple
operating mode do not forward ingress or egress broadcast or multicast
packets until at least one client has logged on.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 781 or “SHOW DOT1X
INTERFACE” on page 786
Examples
This example configures authenticator ports 23 and 24 to discard all
ingress and egress broadcast and multicast packets while the ports are in
the unauthorized state:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23,port1.0.24
awplus(config-if)# dot1x control-direction both
This example configures authenticator port 1 to forward the egress
broadcast and multicast packets and to discard the ingress packets:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# dot1x control-direction in

Table of Contents

Related product manuals