Allied Telesis AT-9028 - Page 898

Chapter 61: LLDP and LLDP-MED
898 Section X: Network Management
awplus(config_if)# lldp transmit receive
Configure the port to send and
receive LLDP advertisements.
awplus(config_if)# lldp location coord-location-
id 16
Use the LLDP LOCATION
command to add the coordinate
location entry, ID number 16, to
the port.
awplus(config_if)# lldp med-tlv-select location
Use the LLDP MED-TLV-SELECT
command to configure the port to
send the location entry in its
advertisements.
awplus(config_if)# end
Return to the Privileged Exec
mode.
awplus# show location coord-location interface
port1.0.15
Use the SHOW LOCATION
command to confirm the
configuration.
awplus# show lldp interface port1.0.15
Use the SHOW LLDP
INTERFACE command to confirm
the port is configured to send the
location entry.
ID Element Type Element
-------------------------------------------
16 Latitude Resolution [not configured]
Latitude 37.29153547
Longitude Resolution [not configured]
Longitude -121.91528320
Altitude Resolution [not configured]
Altitude 10.25000000
Map Datum NAD83-NAVD
Optional TLVs Enabled for Tx
Port Rx/Tx Notif Management Addr Base 802.1 802.3 MED
----------------------------------------------------------------------------
15 Rx Tx -- -- 0.0.0.0 PdSmSdScMa Pv----Pi MpPoLaMf McNpLoPeIn
Transmit optional
LLDP-MED TLV:
Lo = location TLV
Port receives and
sends TLVs.