Need help?Do you have a question about the ALTAI A2 and is the answer not in the manual?
General| Frequency Bands | 2.4 GHz, 5 GHz |
|---|---|
| Type | Wireless Access Point |
| Max Data Rate | 300 Mbps |
| Wireless Standards | 802.11a/b/g/n |
| Operating Modes | Access Point, Repeater |
Describes the overall performance capabilities of the Altai A2 WiFi Access Point/Bridge.
Details the device's compatibility and performance with the 802.11n wireless standard.
Explains the device's capacity, noting it has two radios for access and backhaul.
Lists and briefly explains the various operational modes available for the device's radios.
Guides users on configuring their PC's network connection for wireless access to the A2.
Provides instructions on verifying network connectivity to the A2 device using the ping utility.
Details how to access and log in to the A2's web-based administration interface.
Explains how to find and verify the firmware version and other system details of the A2.
Covers configuration of the device's network modes like Switch and Gateway.
Describes how to configure wireless parameters for AP, CPE, Repeater, and Bridge modes.
Covers essential system management tasks like rebooting and restoring default settings.
Displays the current network mode, IP address, uptime, and radio status.
Shows the address lease table with client MAC and IP addresses for connected users.
Enables scanning for unauthorized access points and displays scan results.
Provides statistics on client associations for the AP mode, including RSSI and VAP.
Monitors bridge associations and statistics for the 5GHz radio, including MAC addresses.
Allows uploading custom logos and configuration profiles for device personalization.
Guides through the process of updating the device's firmware via HTTP or HTTPS.
To Next Page
