1 INTRODUCTION
1.1 TOTAL PERFORMANCE
Altai A2 WiFi Access Point/Bridge provides coverage for outdoor WiFi coverage and enhances
the Altai indoor coverage solution. It combines IEEE 802.11a/b/g/n to offer best WiFi access in
different scenarios.
1.2 COMPATIBLE WITH 802.11N
By adopting MIMO technology, Altai A2 provides up to 300Mbps data rate to 802.11n clients.
1.3 LARGE CAPACITY
Altai A2 has two radios. Both radios can work as access radio to enhance the total capacity of
A2 unit and as backhaul link.
1.4 DIFFERENT OPERATION MODES
There are multiple operation modes for each radio. AP mode means the radio is working for
clients association; CPE mode is used to receive signal from 2.4GHz radio end as backhaul link;
Repeater mode is used to repeat the 2.4GHz radio signal; 5GHz radio can be selected as
backhaul link when enabled Bridge mode and AP when enabled AP Mode; users can also
disable the radio.
This manual is to summarize how to perform configuration for the Altai A2 through web-admin
interface.
2 A2 MODEL AND FIRMWARE VERSION
This manual is applicable for the following models and firmware version:
Product name : A2 WiFi Access Point/Bridge
Model number : A2/A2E
Firmware version: v1.0.6.48
To Next Page
Loading...
