4.5 NTP CONFIGURATION
NTP is a network time protocol for the AP to synchronize the system time. There is no NTP
server IP address by default. If NTP is needed, IP address of the NTP server must be added and
A2 will synchronize with the NTP server. This measure is useful to maintain the network and
make sure all APs using the same system time by setting the same NTP server.
Figure 5 NTP Configuration
NOTE: Click the Update icon to store the changed settings.
4.6 SNMP CONFIGURATION
In the SNMP Manager, the administrator can change the Read Community and Write
Community which is used for security check between AP and SNMP manager. Access Subnet
IP and Access Subnet Mask can be configured to specify the IP address of SNMP Manager and
Access Subnet where SNMP manager is located. Notification Server can be added for SNMP
monitoring of APs. A2 will send SNMP trap packet to the added Notification Server. They are
parameters used for SNMP control between Altai A2 and AWMS system or a third party NMS.
Figure 6 SNMP Configuration
To Next Page
Loading...
