2 LS User Manual
WARRANTY
This instrument is warranted against defects in workmanship, material and design for one (1) year
from date of delivery to the extent that AMETEK will, at its sole option, repair or replace the instrument
or any part thereof which is defective, provided, however, that this warranty shall not apply to instru-
ments subjected to tampering or, abuse, or exposed to highly corrosive conditions.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR IMPLIED
AND AMETEK HEREBY DISCLAIMS ALL OTHER WARRANTIES, INCLUDING, WITHOUT LIMITA-
TION, ANY WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY.
AMETEK SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING, BUT NOT LIMITED TO, ANY ANTICIPATED OR LOST PROFITS.
This warranty is voidable if the purchaser fails to follow any and all instructions, warnings or cautions
in the instrument’s Instruction Manual.
If a manufacturing defect is found, AMETEK will replace or repair the instrument or replace any defec-
tive part thereof without charge; however, AMETEK’s obligation hereunder does not include the cost
of transportation, which must be borne by the customer. AMETEK assumes no responsibility for dam-
age in transit, and any claims for such damage should be presented to the carrier by the purchaser.
CAUTION!
HIGH FORCES ARE OFTEN INVOLVED WITH THE
MATERIAL TESTING PROCESSES.
THE MACHINE IS POWERED BY MAINS SUPPLY
VOLTAGE
CLASS 1 PRODUCT, MUST BE CONNECTED TO A
MAINS SOCKET OUTLET WITH A PROTECTIVE EARTH
CONNECTION
DO NOT POSITION THE EQUIPMENT SO THAT IT IS
DIFFICULT TO OPERATE THE DISCONNECT DEVICE
(MACHINE MAINS INLET SOCKET)
IF THE EQUIPMENT IS USED IN A MANOR NOT SPECI-
FIED BY THE MANUFACTURER, THE PROTECTION
PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED
TO MAINTAIN ALL ASPECTS OF THE SPECIFICATION,
ONLY LLOYD INSTRUMENTS APPROVED ACCES-
SORIES CONNECTIONS AND COMPONENTS SHOULD
BE USED
STRICTLY ADHERE TO ALL SPECIFIED SAFETY
PROCEDURES
READ THIS MANUAL BEFORE USING THE MATERIALS
TESTING MACHINE.
TRADEMARKS
AMETEK is a registered trademarks of AMETEK,
Inc. LLOYD INSTRUMENTS is a trademark of
AMETEK, Inc. Other trademarks are the property
of their respective owners.
SUPPORT
AMETEK Lloyd Instruments Ltd
Steyning Way
Bognor Regis
West Sussex
UK
PO22 9ST
Tel: +44 (0) 1243 833 370
Fax: +44 (0) 1243 833 401
techsupport@ametek.co.uk
www.lloyd-instruments.co.uk
AMETEK Measurement and Calibration
Technologies
8600 Somerset Drive
Largo, FL 33773
USA
Tel: +1-727-536-7831
Tel: +1-800-527-9999 (within USA only)
www.chatillon.com
To Next Page
Loading...
