Ametek LS1 Series - Extensometer Selection and Range

LS User Manual 45
Plotter load Ext
Output 100.0 100
Enabled N mm <
Sample Extenso’r Range
Printout Used 800.00
All EXH750 mm <
< >
Pressing the Extenso’r Used Soft Key will allow the selection of any extensometer currently tted
from the following screen.
Select an extensometer
LS Materials Testing Machine
The left and right arrow ( < > ) Soft Keys will scroll through the list of currently connected extensom-
eters, (theoretically a maximum of 4 with the internal crosshead position always being listed as one
of these). The internal crosshead position extensometer is displayed as the LS materials testing
machine, i.e., LS Press the ENTER key to select the displayed extensometer.
If the selected extensometer has a selectable range, then an additional option will be displayed in the
Test Options screen.
Press a key to change a parameter
The extensometer range will default to the maximum range of the extensometer but can be changed
by pressing the Range Soft Key.
Pressing the Sample Printout Soft Key, toggles between “Result” and “All”. “Result” will print the 4
results and “All” will print the 4 results and the machine parameters.
Pressing the Plotter Output Soft Key, toggles between “Disabled” and “Enabled”. In the “Enabled”
position, the following screen will be displayed where the plotting parameters can be set.
Press a key to change a parameter