Sorensen SGI Series Overview
M550221-01 Rev U 1-7
1.2.3 SGI Series Voltage and Current Specifications
The following tables present the specifications for rated voltage and current, and ripple/noise for
the 10V-1000V models.
* PK-PK ripple/noise, over 20 Hz to 20 MHz bandwidth, is measured across a 1 µF capacitor at
the end of a 6’ load cable with the supply operating at full load and nominal AC line voltage.
** RMS ripple/noise, over 20 Hz to 300 kHz bandwidth, is measured directly across the output
terminals with the supply operating at full load and nominal AC input line voltage.
†
Power level not available in 6U models, but could be produced with paralleled 3U units;
up to
75 kW could be produced by paralleling up to five power supplies. Paralleling will increase
ripple/noise.
††
Models from 10V-30V are not available in 6U chassis.