Safety information 31
1208531 | 03.07.2012
NOTE Check that:
• The roller chassis is not bent or cracked in the area of the ROPS mounting.
• The ROPS has no cracks or fractures.
• All screw connections are tight (note tightening torque).
3.4 Noise levels
The following noise level measurements were carried out by an accredited testing
and monitoring body in accordance with machine directive 2000/14/EEC of the
European parliament and council.
Inspecting and monitoring organization: TÜV Österreich (Austrian technical inspec-
torate) Testing body no. 0408
Tab. 3-1 ARX 4 sound power level
NOTE The obligation to wear ear protection is standardized nationally. In Switzerland
and Germany, this is as of a measured level of 85dB (A) (sound pressure).
3.5 Safety labels on the machine
● Observe and adhere to the rules.
● Keep the safety stickers and signs complete and legible.
● Replace any damaged or illegible stickers and signs immediately.
● You can order new stickers from Ammann Schweiz AG.
From the moment the signs are no longer recognizable and understandable at first
glance, the machine must be shut down until new signs are installed.
WARNING
Hearing damage due to continuous noise level!
Depending on the use of equipment it is possible that the al-
lowed noise level of 85dB (A) will be exceeded.
• Wear ear protectors in accordance with national accident pre-
vention regulations when working at higher noise levels.
Model Value
Measured sound power level ARX 4 = 102 dB (A)
Guaranteed sound power level ARX 4 = 106 dB (A)
Measured sound pressure level at the driver's position ARX 4 = 87.7 dB (A)
To Next Page
Loading...
