Options 73
1208531 | 03.07.2012
Driving with the
right operating le-
ver
1 Move the left operating lever to the neutral position.
2 Driving with the right operating lever
8.3 Rear work light and revolving warning light
Switching the work light and the revolving warning light on and off:
1 Turn the switch:
2a to position 0: Both the work light and the revolving warning light are switched
off.
2b to position 1: The rear revolving warning light is switched on.
2c to position 2: Both the rear work light and the revolving warning light are swit-
ched on.
NOTE If the roller is no longer fitted with a revolving warning light, only the work light
is lit.
8.4 Revolving warning light
8.4.1 Switching on the revolving warning light
1 Turn the switch:
2a to position 1: The revolving warning light is switched on.
The roller may be fitted with a revolving warning light, but the corresponding switch
may be missing. In this case the revolving warning light operates continuously as
soon as the ignition key is in position II.
8.4.2 Positions of the revolving warning light
in operation The revolving warning light is located at the rear on the rollover bar (ROPS) during
operation.
not in operation Fold the rollover protection (ROPS) down for transport or during extended periods of
non-use.
1 Move the driver's seat to the center.
2 Fasten the revolving warning light to the mounting on the inner left side of the
rollover bar (ROPS).
Secure the parking brake firmly.
To Next Page
Loading...
