60 ARX 4
1208531 | 03.07.2012
Fig. 7-4 Vandalism protection cover opened / closed
7.4 Starting the engine
7.4.1 Ignition switch
7.4.2 Starting the engine
1 Fold the vandalism protection cover all the way back.
2 Move the operating lever into the neutral position until it locks in.
3 Put the speed adjusting lever into the idle position.
4 Turn the ignition key clockwise to position III.
5* As soon as the engine starts up release the ignition key.
Fig. 7-5 Starting motor / position of operating lever and speed adjusting lever
P PARK
In this position you can switch on the parking light. The remaining electrical
loads are off.
0Off
All electrical loads are off.
I Ignition on
All electrical consumers can be switched on.
II Pre-heating
III Start
To Next Page
Loading...
