44 ARX 4
1208531 | 03.07.2012
5.1.3 Control lamp functions
Error The Error control lamp lights as soon as the controller recognizes an error. At the
same time, an error code will be shown on the display.
1 Check the machine based on the error code table.
If, after carrying out these checks, the battery charging lamp is still lit, call a specialist.
Battery If the battery charge level control lamp lights up during operation or does not go
off after starting, carry out the following check immediately.
1 Stop the engine.
2 Check the engine for defective or loose V-belt.
If, after carrying out these checks, the battery charging lamp is still lit, call a specialist.
Engine oil
pressure
If the engine oil pressure control lamp lights up during operation or does not go off
after starting, stop the roller and turn off the engine immediately!
1 Check the engine for oil loss and correct oil level.
2* The oil level in the engine is correct: Call a specialist to remedy the problem.
Coolant
temperature
NOTE Danger of engine overheating. Stop immediately!
If the coolant temperature control lamp lights up during operation of the machine,
switch off the engine immediately and top up coolant!
1 Allow the engine to cool down.
2 Remove the radiator cap.
3 In order to avoid scalding, first unscrew the radiator cap one turn and allow the
pressure to drop.
4 As soon as the pressure has dropped, remove the cap and top up the liquid.
5 Check the cooling system for leaks and the radiator/expansion vessel for cor-
rect coolant level.
6* You are unable to find an error: Call a specialist to remedy the problem.
WARNING
Danger of scalding! The cooling circuit is pressurized.
To Next Page
Loading...
