3.6. Lubrication and Maintenance Operations
Second part:
Fill the cooling circuit with clean water. When lled, wait ca •
2-3 min until air escapes and the circuit gets lled. Max ll-
ing rate is 10 l/min (2,6 gal US/min).
Do not close the tank with overpressure plug.•
Start the engine and let it run for 5 minutes for liquid tem-•
perature to reach 82°C (180°F).
Inspect cooling circuit tightness and liq-
uid level on water gauge.
Stop the engine and drain the cooling circuit.•
Note
Repeat this process until clean water ows out.
Fill the cooling circuit:
Install the drain plug, ll the cooling system with new cool-•
ant at the ratio of min 50 % water + 50 % antifreeze.
Wear gloves to protect your hands!
Wear safety glasses or face shield to pro-
tect your eyes!
Fill with the coolant according to the
Section 3.2.3!
To make the change proceed as per the
manual from antifreeze producer!
Rell the coolant to max level. When lled wait ca 2-3 min •
until air escapes and the circuit gets lled. Max lling rate
is 10 l/min (2,6 gal US/min). Close the expansion tank with
overpressure plug.
Start the engine and wait until the tem-
perature reaches 82 °C (180 °F). Check
during your waiting for any leakage of
cooling liquid and check the level on the
indicator.
To Next Page
Loading...
