49AV 70 X
OPERATION MANUAL
Indicator lamp for air lter fouled
Indicator lamp ON signals lter element is fouled above a limit
admissible.
Stop the Machine and replace the lter
element instantly!
Engine lubrication lamp
When switching the key in the ignition box (12) over to “I” posi-
tion and indicator lamp shall go ON, and when engine is started
it must go OFF.
Indicator lamp lighted ON during engine run will signal a de-
fect. Following 5 seconds the acoustic alarm will start, and after
2 minutes the engine will stall automatically – the Machine will
stop and parking brake will be enabled.
Stop the Machine and check oil amount
or nd a defect!
Indicator lamp for engine overheated
This indicator lamp signals the cooling liquid’s max temperature
allowed has been exceeded.
Indicator lamp lighted ON during engine run will signal a de-
fect. Following 5 seconds the acoustic alarm will start, and after
2 minutes the engine will stall automatically – the Machine will
stop and parking brake will be enabled.
Stop the Machine and check cooling liq-
uid amount, or nd out any defect!
Indicator lamp for trac-indicator lights
Indicator lamp ON will signal trac-indicator lights are ON, or
alarm lights have been turned ON.
Neutral indicator lamp
Indicator lamp ON will signal the position of travel controls is in
neutral (N).
Before starting the engine the travel controls (1) shall be in neu-
tral position (N)!
Indicator lamp that the vibration is ON
Indicator lamp ON will signal the vibration is ON.
Indicator lamp for hydraulic oil temperature
Indicator lamp signals max hydraulic oil temperature admissible
has been exceeded. The control lamp lighting up during the en-
gine running signals a defect. After 5 seconds, audible alarm will
be activated and the engine will be stopped automatically – the
machine will stop and the parking brake will be activated.
Stop the Machine and check oil level or
nd a defect!
Check hydraulic oil level
Indicator lamp signals low hydraulic oil level.
When the control lamp lights up, the engine is immediately
stopped and audible alarm is on - the machine stops and the
parking brake is activated.
Engine can only be started when failure
is repaired and oil in hydraulic tank re-
lled to a limit specied!
To Next Page
Loading...
