AMX NXD-500i

Programming
116
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
The following table lists and describes SIP setup commands. Using any of these commands causes the current user to go
offline:
SIP Commands (Cont.)
?PHN-PRIVACY Queries the state of the privacy feature.
The panel responds with the ^PHN-PRIVACY, <state> message.
Syntax:
"’?PHN-PRIVACY’"
Example:
SEND_COMMAND Panel,"'?PHN-PRIVACY'"
^PHN-REDIAL Redials the last number.
Syntax:
"’^PHN-REDIAL’"
Example:
SEND_COMMAND Panel,"'^PHN-REDIAL'"
^PHN-TRANSFER Transfers the call to the provided number.
Syntax:
"’^PHN-TRANSFER, <connection id>, <number>’"
Variable:
connection id = The identifying number of the connection
number = The number to which you want to transfer the call.
Example:
SEND_COMMAND Panel,"'^PHN-TRANSFER, 1, 2125551000'"
SIP Setup Commands
^PHN-SETUP-DOMAIN Sets the realm for authentication.
Syntax:
"’^PHN-SETUP-DOMAIN,<domain>’"
Variable:
domain = The realm used for authentication
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-DOMAIN,asterisk’"
^PHN-SETUP-ENABLE Registers a new user
Once the configuration has been updated, the ENABLE command should be run to
re-register the new user.
Syntax:
"’^PHN-SETUP-ENABLE’"
^PHN-SETUP-PASSWORD Sets the user password for the proxy server.
Syntax:
"’^PHN-SETUP-PASSWORD,<password>’"
Variable:
password = The password for the user name
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-PASSWORD,6003’"
^PHN-SETUP-PORT Sets the port number for the proxy server.
Syntax:
"’^PHN-SETUP-PORT,<port>’"
Variable:
port = The port for the proxy server
Example:
SEND_COMMAND Panel,"’^PHN-SETUP-PORT,5060’"