EasyManua.ls Logo

AMX NXD-500i

AMX NXD-500i
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Programming
68
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
Page Commands (Cont.)
@PPM Set the modality of a specific popup page to Modal or NonModal.
A Modal popup page, when active, only allows use of the buttons and features on that popup page. All other
buttons on the panel page are inactivated.
Syntax:
"'@PPM-<popup page name>;<mode>'"
Variables:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
mode = NONMODAL converts a previously Modal popup page to a NonModal.
MODAL converts a previously NonModal popup page to Modal.
modal = 1 and non-modal = 0
Example:
SEND_COMMAND Panel,"'@PPM-Popup1;Modal'"
Sets the popup page ’Popup1’ to Modal.
SEND_COMMAND Panel,"'@PPM-Popup1;1'"
Sets the popup page ’Popup1’ to Modal.
@PPN Activate a specific popup page to launch on either a specified page or the current page.
If the page name is empty, the current page is used (see example 2).
If the popup page is already on, do not re-draw it.
This command works in the same way as the ’Show Popup’ command in TPDesign4.
Syntax:
"'@PPN-<popup page name>;<page name>'"
Variable:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Panel,"'@PPN-Popup1;Main'"
Activates ’Popup1’ on the ’Main’ page.
Example 2:
SEND_COMMAND Panel,"'@PPN-Popup1'"
Activates the popup page ’Popup1’ on the current page.
@PPT Set a specific popup page to timeout within a specified time.
If timeout is empty, the popup page will clear the timeout.
Syntax:
"'@PPT-<popup page name>;<timeout>'"
Variable:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
timeout = Timeout duration in 1/10ths of a second.
Example:
SEND_COMMAND Panel,"'@PPT-Popup1;30'"
Sets the popup page ’Popup1’ to timeout within 3 seconds.
@PPX Close all popups on all pages.
This command works in the same way as the 'Clear All' command in TPDesign 4.
Syntax:
"'@PPX'"
Example:
SEND_COMMAND Panel,"'@PPX'"
Close all popups on all pages.

Table of Contents

Other manuals for AMX NXD-500i

Related product manuals