System Operations 5-3 System Menu
Site Master User Guide PN: 10580-00252 Rev. J 5-5
System Options 2/2 Menu
Key Sequence: Shift, System (8) > System Options > More
Remote Access Password
This function is valid only with Master Software Tools (MST) v2.21.1 or later. After setting
the password, reboot the instrument (normal power OFF then ON) to provide remote access
security. Only one user then has access at any one time.
The password is first set into the instrument, then used in MST. When prompted in MST,
enter the password into the password text box. The password text box shown in Figure 5-5
may differ from the text box that is displayed on your instrument.
The password can be removed or reset by a Master Reset, by a Factory Default reset, or by a
firmware update (which includes a restart).
Center Freq Share: Select All Modes to have the current center frequency
setting carried over when changing measurement modes. This feature is not
applicable to measurements which do not have a center frequency setting or
to measurements in which the current center frequency setting is outside the
range of the new measurement.
Set Remote Access Password: Press this submenu key to open the
Password text box (Figure 5-5) and Text Entry menu. Type in the desired
password. Upper case and lower case letters and the symbols - _ + .
are the allowed password characters. Press Enter to save or Esc to cancel.
Back: Press this submenu key to return to the “System Options Menu”
on page 5-4.
Figure 5-4. System Options Menu
Warning Do not use SCPI commands with this feature.
Figure 5-5. Remote Access Password Text Box
Back
System Options 2/2
Share CF &
Pwr Offset
All Modes Not Shared
Set
Remote Access
Password
Press Shift for Caps
Use arrow keys to navigate cursor within file name
Enter to Save
Password
To Next Page
Loading...
