EasyManuals Logo

Anviz EP300 User Manual

Anviz EP300
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
circuit.
After checking completed, click [C]to exit.
2.7 T&A status setting
In T&A status, press [] or [] key to shift attendance status. System default
statuses are IN, Pass, OUT.
OUT
09 : 00 26
01/13/11 THU
PASS
09 : 00 26
01/13/11 THU
2.8 T&A
FP only mode:
In T&A status, place registered finger on sensor scanner. After a beep ‘di-’, system
will prompt as following,
FP Verify
Take Off!
Remove your finger. If access granted, green LED indicator will be on with voice
prompt ‘Access granted’. And interface displays as following,
FP Verify
ID 008101
Verified
If access fails, red LED indicator will be on with voice prompt ‘Access denied’. And
interface displays as following,
FP Verify
Input Again
ID+ Password mode:
28

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Anviz EP300 and is the answer not in the manual?

Anviz EP300 Specifications

General IconGeneral
TypeBasic access control reader
Resolution500
CertificationFCC, CE
Product colorBlack
Number of users1000 user(s)
Housing materialCarbon
Scan speed (min)0.5 mm/sec
Fingerprint readerYes
Authentication typeAccess chip/card, Biometric, Password
Display typeLCD
Display size (HxV)128 x 64 mm
Operating temperature (T-T)-10 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Depth35 mm
Width185 mm
Height130 mm

Related product manuals