Anviz EP300 User Manual

In T&A status, input employee ID through number keypad, i.e. 8108.
Pass Verify
ID 8108
Press [OK] key to confirm ID, and input password following prompt,
Input employee password and press [OK] key to confirm. If verification passes,
green LED indicator will be on with voice prompt ‘Access granted’. Else red LED
indicator will be on with voice prompt ‘Access denied’.
ID+FP mode
In T&A status, input employee ID, i.e. 8102
Pass Verify
ID 8102
Press [OK] key to confirm and place finger on sensor scanner. After a beep ‘di-’,
system will prompt as following,
FP Verify
Take off !
Remove your finger. If access granted, green LED indicator will be on with voice
prompt ‘Access granted’. Else red LED indicator will be on with voice prompt ‘Access
denied’.
2.9 Shut down
In time attendance status, keep pressing [OK] key until interface shows as
following,
29

Anviz EP300 Specifications

General

Type	Basic access control reader
Resolution	500
Certification	FCC, CE
Product color	Black
Number of users	1000 user(s)
Housing material	Carbon
Scan speed (min)	0.5 mm/sec
Fingerprint reader	Yes
Authentication type	Access chip/card, Biometric, Password
Display type	LCD
Display size (HxV)	128 x 64 mm
Operating temperature (T-T)	-10 - 40 °C

Weight and Dimensions

Depth	35 mm
Width	185 mm
Height	130 mm