EasyManuals Logo

Apollo Thunderbolt User Manual

Apollo Thunderbolt
222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
Apollo Thunderbolt Software Manual Console Reference 106
Cue Source Select
These two switches determine the input source for the cue bus output. The cue bus
source name is on the switch. The source for the cue is active when its switch is lit.
The source for each cue output can be either the associated dedicated cue bus or the
main monitor mix. The cue sources for each cue are mutually exclusive (both sources
cannot be simultaneously active).
Note: To enable the ability to select the cue for the monitor outputs (via the
control room Monitor Source Select switches), the cue’s source must not be set to
MIX.
MIX
When set to MIX (the default), the cue source is Console’s main monitor mix, summed
with all DAW outputs that are routed to the monitor outs (if applicable). Console’s main
monitor mix faders, mutes and solos are reflected in the cue output in this mode.
CUE (Apollo Rack Models)
When set to CUE, the cue source is the dedicated cue mix, summed
with all DAW outputs that are routed to the same cue outputs (if
applicable). In this mode, the mix of the cue bus is determined by
the cue send controls in the input channel strips and the aux return
strips.
Console’s faders, mutes, and solos are not reflected in the cue
outputs in when CUE is selected (Console’s cue sends are pre-fader).
Note: When CUE is the selected cue source, signals must be sent to that cue’s
bus (via the cue sends) for the cue mix to be heard in the selected cue outputs.
HP & LINE 3/4 (Apollo Twin)
When set to HP, the headphone cue source is the dedicated HP mix,
summed with all DAW outputs that are routed to the HP outputs (if
applicable).
When set to LINE 3/4, the line outputs source is the dedicated LINE
3/4 mix, summed with all DAW outputs that are routed to the same
cue outputs (if applicable).
In this mode, the mix of the cue bus is determined by the cue send
controls in the input channel strips and the aux return strips.
Console’s faders, mutes, and solos are not reflected in the cue outputs in when HP or
LINE 3/4 is selected (Console’s cue sends are pre-fader).
Note: When HP or LINE 3/4 is the selected cue source, signals must be sent to
that cue’s bus (via the cue sends) for the cue mix to be heard in the selected cue
outputs.
Cue Source select
(Apollo rack models)
Cue Source select
(Apollo Twin)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Apollo Thunderbolt and is the answer not in the manual?

Apollo Thunderbolt Specifications

General IconGeneral
TypeAudio Interface
ConnectivityThunderbolt
Bit Depth24-bit
DSPUAD-2
Sample Rate192 kHz
Thunderbolt Ports2
DSP ProcessingUAD-2
Software IncludedUAD Software

Related product manuals