Apollo Thunderbolt Software Manual Console Settings 158
Peak Hold Time
This drop menu sets the duration that the signal peak indicators in the input and send
meters are displayed before turning off. The available values are None, 1 second, 3
seconds (default), 5 seconds, and 10 seconds.
Always On Top
When set to NONE (the default value), a UAD plug-in editor window can be covered by
the Console window when Console is the foreground application.
When set to PLUG-INS, UAD plug-in editor windows always float on top of the Console
and Console Settings windows (when Console is the foreground application), so they can
always be seen and adjusted.
Note: This setting only affects UAD plug-in window behavior within Console. It
does not apply to UAD plug-ins when they are used in other host applications.
Show Device Names
When set to ON, Apollo’s Device Name is displayed in the Meter Bridge.
This feature is intended primarily for use with multi-unit systems. When the Meter Bridge
contains the inputs for more than one Apollo unit, this feature groups the input channels
by device name for easier input identification.
Tip: This feature can also be accessed by right-clicking the Meter Bridge Menu.
The Meter Bridge with Show Device Names OFF (left) and ON (right)
Modifiers Timeout
This option sets the period, in seconds, used for Option Latch operations.
To Next Page
Loading...
Need help?
General
