Page 22
Navigate to Radio menu.
It is advised to scan radio channels for better availability before pairing the sensors because of possible
interference from other devices using same frequency range that might be installed near to your location.
Be patient, it is long-lasting process and can take up to 3 hours. You can skip scanning by now and select
channel at your desire, but this can lead to less good communication between sensors and Aranet
PRO/PRO+ base.
!NOTE! Keep in mind: you will have to repeat all sensors
pairing process if you decide to change radio channel.
You can leave System menu now and switch to Sensors menu for sensors pairing.
To Next Page
Loading...
