Page 41
3.6.4
Network menu
The “Network settings” menu is where you can configure the connectivity of Aranet PRO/PRO+. Wi-Fi
and Ethernet connectivity is supported for connecting to the internet; however, Ethernet connectivity is
preferred for stability. It is also recommended to disable not used network interfaces to lower the processor
load.
Aranet PRO+ P/N TDSBOB03, TDSBOBU3, TDSBOBC3 have built-in GSM LTE 4G modem accepting
MINI size SIM-card. SIM-card as well as Mobile network connection plan are not included in the scope of
delivery and should be purchased by the Aranet PRO+ base owner separately.
3.6.4.1 WIFI menu
By default, Aranet PRO/PRO+ is configured as a Wi-Fi Access Point for easy initial configuration.
However, if you wish this can be changed. The first menu screen is for the Wi-Fi setup where you can
choose between Access Point and Client connectivity.
Factory settings of Aranet PRO/PRO+ Wi-Fi interface are:
• Wi-Fi interface configured as Access Point
o SSID - “Aranet-******” (refer to the label
attached to Aranet PRO/PRO+);
Encryption – WPA2-PSK-CCMP;
o Aranet PRO Mk2 SSID - “Aranet-******”
Encryption – None;
o IP address – 192.168.206.100;
o Subnet Mask – 255.255.255.0
(1) In Access point connectivity it is possible to add/change password to your Aranet PRO/PRO+ Wi-Fi,
as well as change its name, IP address and subnet mask. Apply the changes by Save button.
To Next Page
Loading...
Need help?
General
