EasyManua.ls Logo

Arjo Maxi Sky 2 - Display Symbols Guide; Interpreting Lift Status Icons

Arjo Maxi Sky 2
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
001-15698-EN rev.12
Display Symbols
Following is a description of all the symbols that may appear on the display.
Battery Charge Level
Several symbols showing a battery at a different charge level. These symbols
indicate status regarding the batteries and/or the regular charging system
(see "Battery Information" and "" on page 20 for details).
ECS Indicator
On units equipped with an Enhanced Charging System (ECS) option, this
symbol shows up when the batteries are charging.
RTC (Return to Charge)
This symbol indicates that the RTC function was activated by the hand
control.
RTH (Return to Home)
This symbol indicates that the RTH function was activated by the hand
control.
PPP PPP (Pre-Programmed Position)
This symbol indicates that the PPP function was activated by the hand
control.
Over Duty Cycle
This symbol flashes when the lift is used for a long period without allowing it
to cool down. This security feature disables the function (Up, Sit/Lay or Left/
Right) that is being used beyond recommended duty cycle to prevent
damages.
When the overheat protection is engaged, the function, which exceeded the
duty cycle, is disabled while all other functions remain active.
The red light will stay on during a cooling period. In addition, a single beep
will be heard.
General Malfunction (Warning symbol accompanied with a numeric character)
This symbol flashes when the lift encounters a malfunction.
The lift needs to be inspected / repaired by a qualified service technician.
The red light will stay on and a single beep will be heard.
Maintenance Required (Wrench symbol accompanied with a letter character)
This symbol is shown for 7 seconds (accompanied with 2 beeps) when the
lift is waking up from sleep mode and flashes each 5 seconds to draw user's
attention.
Contact your Arjo service centre for maintenance.
Overweight
This symbol flashes when a transfer is attempted with a load exceeding the
lift's capacity.
The red light will stay on (accompanied with 4 rapid beeps) until the patient
is lowered.
The function is disabled while all other functions remain active.
08
ABC

Table of Contents

Other manuals for Arjo Maxi Sky 2

Related product manuals