Arjo Maxi Sky 2 - Transferring Patients (Loop Slings); Positioning the Patient with Loop Slings

37
001-15698-EN rev.12
Transferring Patients Using Loop Slings
Loop slings are available in many sizes. The correct size sling will be able to support the patient's
shoulders during the transferring procedure.
Positioning the Patient
*Hip loops only available on THA6i model
WARNING: Always hold the spreader bar when near patients to avoid hitting them with it. This could
cause an injury.
WARNING: Ensure any obstructions are removed from the intended route of travel. Injuries could occur.
WARNING: Make sure the sling is not caught on any obstructions. Injuries could occur.
WARNING: Before moving the lift, ensure there is enough clearance with patients to not hit them.
Injuries could occur.
The specific loop sling chosen determines the position of
the patient. Different loop combinations can be used to
allow the patient to be lifted and transferred in positions
ranging from semi-reclined to seated.
Note: Slings with more loops allow additional alternative
positions.
Once the loop sling has been fitted around the patient, it
can be configured in three ways. With each of the three
methods described on the next page, it is necessary to first
connect each shoulder loop of the sling to both sides of the
spreader bar.
3 1 1
2 1 1
1 1 1
1 1 2
3
2
1
2
1
Body position according to loop
strap position combinations
SHOULDERS SHOULDERS
LEGS HIPS*
LEGS