48
001-15698-EN rev.12
Limb Support
The Maxi Sky 2 series of ceiling lifts can be used to assist with procedures when limb needs to be
supported in elevated position.
WARNING: To prevent a fall risk, do not activate RTC or RTH function while performing the limb support
task.
Place the Limb sling around the patient's limb.
Approach the lift so that the spreader bar is close enough
to be able to connect the loops.
Connect the loops to the spreader bar.
Raise the patient's limb using the hand control until
patient's limb is at desired height. Be careful to not over
stretch the limb.
When supporting the patient's limb is no longer required,
lower the spreader bar, put the lift away and remove the
sling.
WARNING: Using the sling is only possible after
examination of the limb by a health professional.
WARNING: When using the lowering function be careful
to not hit the patient with the spreader bar as this could
cause injury.
WARNING: To avoid patient limb from falling, always
confirm that the loops are correctly attached and
remain in tension as the weight of the limb is gradually
taken up. Injury could occur.
WARNING: When using the lowering function be careful
to not hit the patient with the spreader bar as this could
cause injury.
To Next Page
Loading...
