Arlo Go 2 User Manual

10Get Started
Arlo Go 2 LTE/WiFi Security Camera
User Manual
5. Insert the activated SIM card into the camera’s SIM card slot.
Align the SIM card so that the the side of the card with the notch is at the top, as shown.
6. Press the edge of the SIM card until it locks into place and you hear a click.
Note: The SD card slot is located next to the SIM card slot. For information about using an
optional SD card, see Install a micro SD card in your Go 2 Camera on page 52.
7. Replace the battery.
8. Slide the camera back inside the camera housing until it clicks.
Use the Arlo app to set up your Go 2 Camera
We recommend that you charge the battery before mounting your camera. The indoor
charging cable that came with your camera works with most power adapters.
1. Download the Arlo app on your smartphone or tablet.
2. Open the Arlo app.
3. Tap Add Device.

Arlo Go 2 Specifications

General

Type	IP security camera
Built-in light	Yes
Placement supported	Outdoor
Connectivity technology	Wireless
Maximum operating distance	91 m
Form factor	Bullet
Mounting type	Ceiling/wall
Product color	White
Country of origin	China
Ethernet LAN	No
Mobile network generation	4G
Field of view (FOV) angle	130 °
Detection distance	7 m
Alert notification type	E-mail, Push notification
LED type	IR
Infra-red wavelength	850 nm
Night vision distance	7.62 m
Number of illumination LEDs	2
Total megapixels	2 MP
Maximum resolution	1920 x 1080 pixels
Number of cameras	1
Digital zoom	12 x
Power source type	Battery
Operating temperature (T-T)	-20 - 45 °C
Sensor type	-
Harmonized System (HS) code	8525890000

Weight and Dimensions

Depth	120 mm
Width	64.2 mm
Height	86 mm
Weight	490 g
Package depth	179 mm
Package width	161 mm
Package height	115 mm
Package weight	792 g