Arlo Go 2 - Tips for Optimal Wifi Performance; Connect Your Mobile Device to a 2.4 Ghz Wifi Network During Setup

20LTE and WiFi network connections
Arlo Go 2 LTE/WiFi Security Camera
User Manual
Change your Go 2 network mode
1. Open the Arlo app.
2. Tap Settings > My Devices.
3. Select the camera.
4. Tap Connected to.
5. Select the option you prefer:
• WiFi Network. Toggle Network on and o.
• Cellular Network. Toggle Cellular Data on and o.
Tips for optimal WiFi performance
The distance between WiFi devices can aect the WiFi signal:
• Maximum recommended distance. Check your WiFi router to verify its wireless range.
In general, we recommend placing your camera within 300 feet (90 meters) of your WiFi
router. The maximum line-of-sight range is reduced by each wall, ceiling, or other major
obstruction between the router and the camera.
• Minimum recommended distance. To reduce WiFi interference, allow at least 6.5 feet (2
meters) between your camera and any other Arlo cameras that you install.
These materials can reduce WiFi signal strength if they are located between WiFi devices:
• Unusually thick walls and ceilings
• Brick
• Concrete
• Stone
• Ceramic
• Glass, especially mirrors
• Metal
• Large quantities of water, such as the water in a sh tank or water heater
Connect your mobile device to a 2.4 GHz WiFi
network during setup
During setup, if you’re using a WiFi connection, the smartphone or tablet you’re using must
connect to the same WiFi network as the Arlo Go 2 Camera.