Arlo Go 2 User Manual

55SD Card Storage
Arlo Go 2 LTE/WiFi Security Camera
User Manual
Remove a micro SD card
It’s important to safely eject the micro SD card.
If you remove an SD card while information is being recorded on it, the SD card might become
permanently unusable or the les on the card might be corrupted.
1. Open the Arlo app.
2. Tap your Go 2 Camera.
3. Tap Storage Settings > SD Card Recording.
4. Tap Safely Eject SD Card.
5. Wait for the Unmounting SD Card progress message to close.
6. Bring the Arlo Go 2 Camera indoors.
We recommend that you bring your camera indoors before removing its housing to avoid
potentially exposing the inside of the camera to water intrusion.
7. Press the release button to release the camera from its housing.
With a click sound, the camera slides partially out of the housing.
8. Pull the camera until it separates from the housing.
9. Remove the SD card by pressing in on the edge of the card until it ejects.
Arlo SD card recording is disabled until you install an SD card.
Micro SD card

Arlo Go 2 Specifications

General

Type	IP security camera
Built-in light	Yes
Placement supported	Outdoor
Connectivity technology	Wireless
Maximum operating distance	91 m
Form factor	Bullet
Mounting type	Ceiling/wall
Product color	White
Country of origin	China
Ethernet LAN	No
Mobile network generation	4G
Field of view (FOV) angle	130 °
Detection distance	7 m
Alert notification type	E-mail, Push notification
LED type	IR
Infra-red wavelength	850 nm
Night vision distance	7.62 m
Number of illumination LEDs	2
Total megapixels	2 MP
Maximum resolution	1920 x 1080 pixels
Number of cameras	1
Digital zoom	12 x
Power source type	Battery
Operating temperature (T-T)	-20 - 45 °C
Sensor type	-
Harmonized System (HS) code	8525890000

Weight and Dimensions

Depth	120 mm
Width	64.2 mm
Height	86 mm
Weight	490 g
Package depth	179 mm
Package width	161 mm
Package height	115 mm
Package weight	792 g