Arlo Go 2 User Manual

45Modes, Rules, and Alerts
Arlo Go 2 LTE/WiFi Security Camera
User Manual
If you use more than one enabled mobile device, you might be asked to select an Arlo
device to connect it to.
10. To select the preferred mobile device, tap the device and then tap Next.
11. Tap Save.
For troubleshooting tips, see Troubleshoot Arlo Geofencing on page 68.
Geofencing with multiple mobile devices
Arlo Geofencing works with multiple mobile devices.
Arlo uses the rst-in, last-out principal to manage households where more than one person
uses geofencing. If everyone leaves home with their mobile devices, this triggers an away
state. Since no one is inside the geofence, your cameras are armed. When the rst person
comes home (rst in), their mobile device is now inside the geofence, triggering the home
state and your cameras are disarmed. If one person leaves, but another is still home, the
cameras stay disarmed in the home state until the last person leaves (last out).
We recommend that you enable geofencing only for the mobile device that each person
carries every day. For example, if you use a smartphone and a tablet, and you take your phone
when you leave, set your phone as an Enabled Device in your Geofencing settings. Don’t set
your tablet as an enabled device, because Away mode won’t be triggered when you go out
and leave your tablet home.
The Geofencing mode only changes from Home to Away when all enabled mobile devices are
outside the Device Location in your Geofencing settings.
To review which mobile devices participate in geofencing, open the Arlo app and check the
Enabled Devices page in Geofencing settings (in the Modes section of the Arlo app). Remove
any devices that you don’t want to trigger Home/Away mode changes.
Make sure that these conditions are met:
• Your Arlo devices are online.
• Geofencing is enabled.
• Your friends’ and family’s mobile devices are added to your account.
For information about adding devices, see Enable or disable geofencing for friends’ mobile
devices on page 46.
• (Required when your friend wants to participate in geofencing.) Your friend is logged in to
the Arlo app on his or her mobile device and the GPS or location service is enabled on your
friend’s mobile device.

Arlo Go 2 Specifications

General

Type	IP security camera
Built-in light	Yes
Placement supported	Outdoor
Connectivity technology	Wireless
Maximum operating distance	91 m
Form factor	Bullet
Mounting type	Ceiling/wall
Product color	White
Country of origin	China
Ethernet LAN	No
Mobile network generation	4G
Field of view (FOV) angle	130 °
Detection distance	7 m
Alert notification type	E-mail, Push notification
LED type	IR
Infra-red wavelength	850 nm
Night vision distance	7.62 m
Number of illumination LEDs	2
Total megapixels	2 MP
Maximum resolution	1920 x 1080 pixels
Number of cameras	1
Digital zoom	12 x
Power source type	Battery
Operating temperature (T-T)	-20 - 45 °C
Sensor type	-
Harmonized System (HS) code	8525890000

Weight and Dimensions

Depth	120 mm
Width	64.2 mm
Height	86 mm
Weight	490 g
Package depth	179 mm
Package width	161 mm
Package height	115 mm
Package weight	792 g